产品详情：IC693CHS392J 10插槽扩展底板

IC693CHS392是一款与90-30系列平台兼容的扩展基板。该硬件允许承载90-30系列模块的附加基板的互连，以最大化中央控制器的能力并符合系统的控制要求，特别是适应更多数量的I/O点和实现特殊功能。IC693CHS392以前由GE Fanuc Automation制造，现在被艾默生自动化收购。该基板提供十(10)个安装插槽，最多可安装10个90-30系列标准I/O模块和可选模块。该基板与CPUs 331、340和341兼容使用，其中最多可互连四(4)个基板，CPU 350和更高版本最多可安装七(7)个基板。将基板与CPU基板互连时，最大电缆长度不得超过50英尺或15米，否则，CPU无法识别扩展基板，或者整个配置无效。此外，智能模块(如PCM、ADC、BEM330和CMM模块)与扩展基板的安装不兼容。这些模块安装在CPU基板上。除了I/O插槽之外，该基板还提供了一个电源插槽，用于供电和配电的电源模块安装在该插槽中。还提供扩展端口，允许与其他扩展基板互连。该基板仅设计用于面板安装，通过位于硬接线最左侧和最右侧的安装片固定。还必须遵守正确的接地，以保护模块并最大限度地降低电气噪声。

IC693CHS392基板是GE Fanuc的扩展基板。它与90-30 GE系列PLC系统兼容。它是一个PLC机箱，但也可以用作不同位置的其他I/O的扩展。基板与PLC系统一起使用，或者通过将其与使用PCI卡的个人计算机连接来使用。它可以一次连接多达7个CPU，具体取决于CPU型号。基板的额定电压为5伏DC。它的额定电流为150毫安。基板长443毫米，宽142毫米，高130毫米。IC693CHS392基板的右侧配有一个25针母D型I/O扩展连接器，可与其他基板有效连接。

IC693CHS392底板有一个电源端口、一个CPU插槽和非CPU插槽。它可以很容易地安装在90-30系列PLC系统中。双列直插式开关也与所有的槽一起位于基板中。IC693CHS392基板采用开放式结构，在安装和更换过程中可轻松操作。它只能用于室内应用，并应彻底防止水溅。基板应远离所有灰尘和热源。扩展槽支持许多设备，但不支持智能选项模块，如PCM、ADC和CMM设备。在安装过程中，互连扩展底板与CPU底板之间的距离不得超过15米。

IC693CHS392J

IC693CHS392 is an expansion substrate compatible with the 90-30 series platform. This hardware allows for the interconnection of additional substrates carrying 90-30 series modules to maximize the capacity of the central controller and meet the control requirements of the system, especially to accommodate a larger number of I/O points and achieve special functions. IC693CHS392 was previously manufactured by GE Fanuc Automation and is now being acquired by Emerson Automation. This substrate provides ten (10) installation slots and can accommodate up to ten 90-30 series standard I/O modules and optional modules. This substrate is compatible with CPUs 331, 340, and 341, and can interconnect up to four (4) substrates. CPU 350 and higher versions can install up to seven (7) substrates. When interconnecting the substrate with the CPU substrate, the maximum cable length should not exceed 50 feet or 15 meters. Otherwise, the CPU cannot recognize the expansion substrate or the entire configuration is invalid. In addition, the installation of intelligent modules (such as PCM, ADC, BEM330, and CMM modules) is not compatible with the expansion substrate. These modules are installed on the CPU substrate. In addition to the I/O slot, the substrate also provides a power supply slot where power modules for power supply and distribution are installed. Expansion ports are also provided to allow interconnection with other expansion substrates. This substrate is only designed for panel installation and is fixed by mounting plates located on the far left and far right sides of the hard wiring. Proper grounding must also be followed to protect the module and minimize electrical noise.
The IC693CHS392 substrate is an extension substrate of GE Fanuc. It is compatible with the 90-30 GE series PLC system. It is a PLC chassis, but can also be used as an extension for other I/Os in different locations. The substrate can be used together with the PLC system or by connecting it to a personal computer using a PCI card. It can connect up to 7 CPUs at once, depending on the CPU model. The rated voltage of the substrate is 5 volts DC. Its rated current is 150 milliamperes. The substrate is 443 millimeters long, 142 millimeters wide, and 130 millimeters high. The right side of the IC693CHS392 substrate is equipped with a 25 pin female D-type I/O expansion connector, which can be effectively connected to other substrates.
The IC693CHS392 motherboard has a power port, a CPU slot, and a non CPU slot. It can be easily installed in the 90-30 series PLC system. The dual inline switch is also located in the substrate along with all slots. The IC693CHS392 substrate adopts an open structure, which can be easily operated during installation and replacement. It can only be used for indoor applications and should be thoroughly protected from water splashing. The substrate should be kept away from all dust and heat sources. The expansion slot supports many devices, but does not support intelligent option modules such as PCM, ADC, and CMM devices. During the installation process, the distance between the interconnect expansion board and the CPU board shall not exceed 15 meters.