负载共享线连接到端子10和11，负载信号线连接到端子11和12。第11个端子在负载共享和负载信号功能之间共享，第11个端子是负极端子连接器，而端子10和12是正极连接器。该型号的负载分配输入指定为0-6 Vdc。

当连接屏蔽线路时，需要从两端去除屏蔽层上的外部绝缘层，这样会露出盘绕的屏蔽层；永远不要切断盾牌。

在使用控制装置之前，建议目视检查模型，确保检查螺丝完好无损，端子无破损或裂缝，并检查所有刻度盘，确保没有任何破损或损坏，因为这可能会影响装置的性能.

安装控制装置时，务必保护控制装置免受水或冷凝的影响，如果控制装置受潮，可能会导致模型出现故障，并妨碍模型运行。

9905-021

The Woodward 2301A series 9905-021 controller is provided by A Zhangzhou Fengyun and is a reverse acting low-voltage model with an actuator current of 0-200 mA. This model is also a separate actuator model and does not provide a deceleration ramp. When connecting the device to a 20-40 Vdc power supply, use terminals 15 and 16, with the negative lead connected to terminal 15 and the positive lead connected to terminal 16.

Connect the load sharing line to terminals 10 and 11, and the load signal line to terminals 11 and 12. The 11th terminal is shared between load sharing and load signal functions, with the negative terminal connector and terminals 10 and 12 being positive connectors. The load distribution input for this model is specified as 0-6 Vdc.

When connecting shielded lines, it is necessary to remove the external insulation layer from both ends of the shielding layer, which will expose the coiled shielding layer; Never cut off the shield.

Before using the control device, it is recommended to visually inspect the model to ensure that the screws are intact, the terminals are not damaged or cracked, and to inspect all dials to ensure that there is no damage or damage, as this may affect the performance of the device

When installing the control device, it is essential to protect it from the influence of water or condensation. If the control device becomes damp, it may cause the model to malfunction and hinder its operation.