伍德沃德INCs 2301A负载和共享控制装置9903-327是一个可以与同一系列中的另一个控制装置一起设置的控制装置，当连接在一起时，使用最小的燃料量来控制和驱动与9903-327连接的装置。这种控制可在反向作用和正向作用装置中实现，用于单个或双致动器。这种控制有多种电压型号，高压或低压，必须与至少15 W的电源一起使用。

对于速度和相位匹配(SPM)同步器，控制需要通过屏蔽线连接，整个同步器的稳定性需要贯穿整个同步器；同步器和护罩不得直接连接。增益电位计处于最高顺时针设置时，峰值性能并不总是可能的；有时，为了保证在许多不同条件下的稳定性，电位计必须减小到最小。

该控制器包含29个端子，端子20和21连接装置和致动器，当连接致动器和控制器时，正极引线必须连接到端子20，负极端子必须连接到端子21；端子25和26连接SPM和装置。电线屏蔽不需要暴露50 mm或更长的电线，暴露的电线会导致装置不能正常运行。

9903-327

Woodward INCs 2301A load and shared control device 9903-327 is a control device that can be set together with another control device in the same series. When connected together, it uses the minimum amount of fuel to control and drive the device connected to 9903-327. This control can be achieved in both reverse and forward acting devices, for single or dual actuators. This control has multiple voltage models, high or low, and must be used with a power supply of at least 15 W.

For speed and phase matching (SPM) synchronizers, control needs to be connected through shielded wires, and the stability of the entire synchronizer needs to run through the entire synchronizer; The synchronizer and cover shall not be directly connected. When the gain potentiometer is set at its highest clockwise position, peak performance is not always possible; Sometimes, in order to ensure stability under many different conditions, the potentiometer must be minimized.

The controller contains 29 terminals, terminals 20 and 21 connect the device and actuator. When connecting the actuator and controller, the positive lead must be connected to terminal 20, and the negative terminal must be connected to terminal 21; Terminals 25 and 26 are connected to the SPM and device. Wire shielding does not require exposing wires of 50mm or longer, as exposed wires can cause the device to malfunction.